Speed sensor from TM NH to calibrator zurf on a bogballe.

[tomildinio]

Yellow

I would like to mount a speed sensor on the tm140 for the zurf box. There looks to be no standout method on either rear axle or prop shaft. Has anyone any pics of a similar mount.
There is no iso plug in a tm either unfortunately.

Many thanks

Tom

 

[Salopian_Will]

Yellow

I would like to mount a speed sensor on the tm140 for the zurf box. There looks to be no standout method on either rear axle or prop shaft. Has anyone any pics of a similar mount.
There is no iso plug in a tm either unfortunately.

Many thanks

Tom

Not done with a Zurf but presume it is a magnet system? If so then we have just mounted them on the propshaft with jubilee clips on a TM.

Can you upgrade your existing system to use a patchwork black box for GPS speed control and section control? That would be the ideal solution but a lot more expensive I appreciate.

 

[tomildinio]

We wont talk about Gps just yet...

I'll poke around prob shaft and see where I can get to. Thanks will.

 

[Salopian_Will]

We wont talk about Gps just yet...

I'll poke around prob shaft and see where I can get to. Thanks will.

You might just but a bit of something plastic between the shaft and the magnet to give a snug/tight fit.

 

[sahara]

This is what we have on our TM, it's a speed sensor for the control box on our Kubota fert spreader.

 

[oil barron]

Can you not take the Radar speed from a TM?

 

[tomildinio]

How I do that?

 

[oil barron]

How I do that?

Newholland Tm wheel speed sensor

Hi everyone. Just got a new sprayer and it needs to be plugged into a wheel speed sensor port. Our Tm has in the past had a radar kit fitted to it to get a moe accurate dash reading but I was wondering if anyone knows if you can get a cable or is there a cable already connected some where in...

thefarmingforum.co.uk

 

[tomildinio]

I have these 2 spade plugs for speed under the dash.
I guess buy a cable and plug that fits the zurf and cut it open and then spade off the speed wires in it and plug it in here and see what happens?
I have a gps but it wont talk to zurf so am trying a sensor input.

 

[Lincsman]

This is what we have on our TM, it's a speed sensor for the control box on our Kubota fert spreader.
View attachment 959342

Mine is the same, has worked perfectly with two different bogballe systems now.

 

[Tm 140]

This is what we have on our TM, it's a speed sensor for the control box on our Kubota fert spreader.
View attachment 959342

Very same here also on 2 tms. Picks up the signal perfectly, it doesn't even have to be that close to the studs

 

[Bumble Bee]

Can you not take the Radar speed from a TM?

Not very good in tall crops. You get false readings.

 

[Bumble Bee]

This is what we have on our TM, it's a speed sensor for the control box on our Kubota fert spreader.
View attachment 959342

We have exactly the same setup on our TM and KRM. Works well.