Speed signal wire MF 6400

[Massey 6470]

Any body know where to get the speed out pulse from a Massey 6400 series without datatronic

 

[Pheasant Surprise]

Have you got a round 16 pin socket (not nessarily all pin positions populated) in the cab?

 

[Glaws]

You need to run a wire from pin 2 of the big connector on the back of the dashboard.
Then bridge this wire to earth with a 1ohm resistor.
Connect the other end to a convienient plug to plug your implement into. Most folk use the spare pins in the socket as mentioned above.
The just set your dash to Forward, pto, or engine speed and it should work a treat.

 

[Pheasant Surprise]

You need to run a wire from pin 2 of the big connector on the back of the dashboard.
Then bridge this wire to earth with a 1ohm resistor.
Connect the other end to a convienient plug to plug your implement into. Most folk use the spare pins in the socket as mentioned above.
The just set your dash to Forward, pto, or engine speed and it should work a treat.

Thanks. As stated in this post, but without the requisite detail.