Splitting Claas liner rotor

[valtraman]

I need to get into rotor of liner 2800, can someone tell me what to do

 

[Speedstar]

take the bolts out right round about it, & the height linkage off & it should come apart what is wrong with it ?

 

[davidroberts30]

Dugga Dugga certainly speeds job up

 

[Lofty1984]

Two locking nuts on the top and it will drop the whole lot off the frame

 

[valtraman]

take the bolts out right round about it, & the height linkage off & it should come apart what is wrong with it ?

Broken shaft inside

 

[organicguy]

We did ours, either the shaft or the wheels have to come off the bottom of the rotor. I think we undid everything then had to spin the wheels off. can't remember if there was a locking nut or pin.

 

[valtraman]

I have it stripped out , gearbox pulled up of top of rotor looks likes just a big circlip to take off then I presume it’s all the Allen studs underneath to undo then the rotor will split??

 

[valtraman]

We did ours, either the shaft or the wheels have to come off the bottom of the rotor. I think we undid everything then had to spin the wheels off. can't remember if there was a locking nut or pin.

Was that a 2800?

 

[organicguy]

Was that a 2800?

2700 I think, could check but is in field tonight.
Ours was a leaking oil seal in the bottom. caused by rust behind the seal, where stood outside with rotor up.
Cannot remember which way the shaft went out, but i know we were stuck for a while until we unthreaded the shaft. Cannot remember whether there was a locking pin or something in the bottom of the shaft.
Sorry, not much help, DOB.

 

[puntabrava]

Dugga Dugga certainly speeds job up

Is it not Ugga Dugga

 

[davidroberts30]

Is it not Ugga Dugga

Depends if your loosening or tightening ‍♂

 

[Neil MP]

Is it not Ugga Dugga

Is everywhere else… but Wales!

 

[Triangle]

Is everywhere else… but Wales!

The 18v DeWalt gets called big windy because we have a smaller 18v bosch thats little windy ironicly iv never owned a air powerd windy gun