Square bale handler

[Bob c]

Forgot about them. All their muck grabs have the tines in the bottom beam though, does that mean they're going to twist off if I pick bales up with them?

Pays your money and take your choice

 

[Forever Fendt]

This one had tines in bottom beam made from 120x120 x8 box and the brackets 40mm thick overlap the bottom beam , there are folded plates on the side of 10 mm and there is a 20 mm plate welded inside the bottom beam at the point the side member welds on so it’s not just attached to one wall off the box there is no way it’s going to bend , Having said that the fork with tines set up below the bottom beam is far superior for unloading trailers at the barn , it holds the bales firmer and tines less likely to pull through bale

 

[Richard Smyth]

Guess I should get the welder out ready for when mine snaps the bottom beam out.

still in build phase here but was picking 3 x 700 kg bales this year with it.