t7.200 power command

[Propperjob]

How do you calibrate the gear box

 

[joe o]

Hold up and down shift, start up,release up and down shift,trans oil temp will be shown in middle display on dash or on gear display if non sidewinder, handbrake on select forwards on shuttle release clutch (shouldn't move), press up shift until "A" is on display where temp was, press auto once sit back and let it do calibration. "END" will be shown when finished select neural turn off and leave 20 seconds for it to save job done [emoji106]

 

[Propperjob]

Thanks but it won't calibrate it rev's up as if it's going to the calibration then stops

 

[Landrover]

On a similar note anyone know how to calibrate the front axle suspension, mine seems to be stuck in the middle and not working ?

 

[cosmagedon]

Thanks but it won't calibrate it rev's up as if it's going to the calibration then stops

Any error codes pop up? From memory they start with a U

 

[Ali_Maxxum]

Thanks but it won't calibrate it rev's up as if it's going to the calibration then stops

Oil temp not high enough that I think?

 

[Ali_Maxxum]

On a similar note anyone know how to calibrate the front axle suspension, mine seems to be stuck in the middle and not working ?

Not sure on that myself but I know you can do it yourself, dealer was out with me about a year ago and calibrated mine in 30seconds dead! No laptop nothing, give your dealer a ring and they should tell you.... orrrrr thinking about it, could be in the operators book?

 

[cosmagedon]

I'm sure you need the diagnostic plug to get into the H menu to calibrate the suspension, that's how its done on Tm's.

 

[Farmer mk1]

Yeah you need the diagnostic plug to get to the h menu. IF you get one you go to the suspension icon and enter, then hold the suspension button on the arm rest and it will start doing its up down up and down to centre. If it won't do it then there is something a miss like the potentiometer is broke or the accumulator diaphragm is dead and has no bounce in it. A quick test is to get the suspension to drop, take off accumilator and if any oil comes out the side with the gas in then it is dead.

 

[Landrover]

Where can I get a diagnostic plug from......?

 

[Farmer mk1]

You won't be able to get one. Unless you find the plug on a website some where and connect the two pins up what you need. You can just get some bullet connectors and a piece of wire joining them and put it in the right pins and it will show the h menu.