do you deal with lincoln weldersThe welds will be perfectly fine, I do sell lots of them but they are not as easy to run as the better quality ones.
do you deal with lincoln weldersThe welds will be perfectly fine, I do sell lots of them but they are not as easy to run as the better quality ones.
not sure what it is called but i can run .8 and 1 mm wire but need a feed wheel for the 1.mm does that sound rightYes we do, however it does depend on your requirement ?
thats it what site is that from cheersView attachment 47462 drive roller which grips the wire ? showing one for .8mm and 1mm wire
yes it does .6 .8 so not 1.0 which is what i needdoes your feed roller not have 2 grooves and you just reverse it . the size will be stamped on the side.
need a new one it will be 1.0 and 1.2 mm ( you may need two if its a four roll feed unit ) you will also be better with a new 1/1.2 lineryes it does .6 .8 so not 1.0 which is what i need
yes it does .6 .8 so not 1.0 which is what i need
Might do if you were running along torchI've been running 1.0mm wire in a 0.8mm roller for several years no problem.
Might do if you were running along torch
@Welding Supplies Direct do you do deals on plasma consumables? am spending a fortune on tips and electrodes! prob £700 last month!
Are these on hand plasma or mechanised?yes, i have a air dryer and filter system. i am running two thermal dynamic plasma cutters probably 6 hours continuous cutting every day, on each cutter 6 days a week! I'm using 2 sets of consumables per cutter per day!
@Welding Supplies Direct do you do deals on plasma consumables? am spending a fortune on tips and electrodes! prob £700 last month!
http://www.beal.org.uk/
Also another good one which was only recommended to me recently!
Do you do hard facing rods, looking for 1040 i think it said on the old pack i used..Yes we do, however it does depend on your requirement ?