Tractor loader headstock swop info

[NewlandFarmServices]

Does anyone no if a headstock from a fendt cargo loader go onto another type of loader or as I think might be the case the dimensions of where the 2 pins attach might be different etc.

Basically remove the whole headstock as it's had a matbro conversion onto the original euro, leaving no headstock on it. Will this who headstock fit other makes such as Mx or quickie etc.

The pins are 4cm diameter.

 

[Tarw Coch]

Does anyone no if a headstock from a fendt cargo loader go onto another type of loader or as I think might be the case the dimensions of where the 2 pins attach might be different etc.

Basically remove the whole headstock as it's had a matbro conversion onto the original euro, leaving no headstock on it. Will this who headstock fit other makes such as Mx or quickie etc.

The pins are 4cm diameter.

4cm? Do you mean 40mm?
In old money one is approx four inch, the other inch and a half

 

[Grassman]

4cm? Do you mean 40mm?
In old money one is approx four inch, the other inch and a half

4 cm is 40mm.

 

[Grassman]

Does anyone no if a headstock from a fendt cargo loader go onto another type of loader or as I think might be the case the dimensions of where the 2 pins attach might be different etc.

Basically remove the whole headstock as it's had a matbro conversion onto the original euro, leaving no headstock on it. Will this who headstock fit other makes such as Mx or quickie etc.

The pins are 4cm diameter.

Pictures might help

 

[NewlandFarmServices]

Yes will do once done this job. Internet playing up so taking ages to do anything.

 

[Chae1]

Have you sold it!?

 

[NewlandFarmServices]

Have you sold it!?

Not quite it's in discussion.

 

[NewlandFarmServices]

Well the 2 pins on either side from the loader to the headstock are 40mm pins. The gap between the widest part of the brackets is 76mm. The bush is 60mm. The overall width of the headstock is 115cm (1150mm). The distance from the top pin to the bottom pin is 9 inches.

 

[NewlandFarmServices]

Any help?

 

[Joe S]

Any help?

Curiosity got the better of me and went and ran a tape over a quicker loader and it won’t fit as a suspected they are different...

 

[balerman]

MX T series 1140mm total width,holes are 9 inch centres,bottom pins are 40mm top ones are 35mm.Probably could be made to fit.

 

[NewlandFarmServices]

MX T series 1140mm total width,holes are 9 inch centres,bottom pins are 40mm top ones are 35mm.Probably could be made to fit.

Thanks. Iv been to see a m8 with a JD loader and his were similar width give take cm and pins the same but others were bit wider.

 

[Sid]

I have swapped a headstock on the previous series Quickie to new series on a new machine. That's fine but Quickie told me the new one wont fit the old one geometrically. It will foul.
Dealers issue not mine as part of deal but be aware. Call to loader manufacturer would be easiest option.

Reason for swap is we run MX face plate, machine was euro.

 

[NewlandFarmServices]

Thanks. Yes might ring Mx up see if can share some light as prob get that on my Deere.