Trutest ID5000 problem

[Norfolk Hill Farmer]

The above showing under load on the screen and wont weigh properly.
Anyone got any thoughts, suggestions or experience
Tia

 

[Bury the Trash]

are you sure its not the load bars ? damp got in them, their wiring prob/damage?

at the unit check the connector(s) going in that the plugs are not having a less than perfect connect up.

inside the unit if you are able to open it and get in and check that the FPC 's/FFC from the load bar inlet plugs disconnect and reconnect them being careful not to damage them . .

this is an example photo of a FPC/FFC its a small multiple wired cable with a plug on the end

it plugs in a little socket and they can cause issues if not snug /well pushed in
some have a latch on them so they should be fine anyway but the ones that just push in can work loose if the unit gets a bang or it wasnt pushed in its socket well enough when it was built originally