Half Pint
Member
The drill is a 2013 model. I first noticed a problem with the the interactive depth control not working the drill going past the set depth to full depth. After trying resetting the required depth and it not working I resorted to the manual depth control on the main lift ram to get the sowing done before the rain arrived.
At the same time the low lift also stopped working.
A few fields later the interactive depth control started working but not the low lift or no lift ( the setting for pulling in the markers without lifting the drill ).
The light on the depth solenoid comes on as the drill reaches the set depth and goes off when the drill is lifted. The light on the height solenoid is fully on with no lift switched and becomes fully bright at the set low lift level but in both cases the drill lifts to full height. Both these valves are powered closed and when removed from the valve block appear to operate when switched.
The valves and their solenoids have been switched around ( the depth one put to the lift limit and visa versa ) but the problem remains the same, the depth working but the lift limit not.
Any advice would be greatly appreciated. Many thanks.
At the same time the low lift also stopped working.
A few fields later the interactive depth control started working but not the low lift or no lift ( the setting for pulling in the markers without lifting the drill ).
The light on the depth solenoid comes on as the drill reaches the set depth and goes off when the drill is lifted. The light on the height solenoid is fully on with no lift switched and becomes fully bright at the set low lift level but in both cases the drill lifts to full height. Both these valves are powered closed and when removed from the valve block appear to operate when switched.
The valves and their solenoids have been switched around ( the depth one put to the lift limit and visa versa ) but the problem remains the same, the depth working but the lift limit not.
Any advice would be greatly appreciated. Many thanks.
