Valtra error codes

[Giles1]

Any Valtra experts out there? 6350 Autocontrol Diagnosis light is flashing 3 times,then a pause,then flashing twice.No error code coming up on any screens.

 

[Valtra 8950]

Most likely your position sensor.

 

[Giles1]

Gone pear shaped you mean?And thanks for the reply.

 

[Valtra 8950]

Some times the wires can be broken or the conector isn't in right. What's the arms doing? The flashing is fault 32 in the book.

 

[yellowfrog]

go round to back of tractorlook behind centre of crosshaft there is a sensor with a plug on it take off plug cleen with contact cleaner put back on . had it happen loads of times with our valtras

 

[Giles1]

Thanks yellowfrog,will try and find the sensor.
8950, my handbook doesn't say what fault 32 is.Would it be the one yellowfrog mentions?The arms seem to be working ok.

 

[Valtra 8950]

Tbh ours flashes all the time but doesn't seem to affect it.

 

[Giles1]

Thanks for the help.Problem diagnosed.Lower link arm (draft) sensor failure.Code 32 was a code for a fault with this area of electrics.Built into the pin attaching lower link to back end.Pin fine but sensor knackered,all integral so can't remove sensor unit.£350 plus to replace it.Not happening surprisingly.

 

[Valtra 8950]

Or not so bad, not needed unless your ploughing with it.