I use to fit loads when I worked at dealer, there’s nothing two technical just follow the instructions and take your time.Anyone fitted one themselves? Easy enough to do?
I use to fit loads when I worked at dealer, there’s nothing two technical just follow the instructions and take your time.
Ideally you want to fit the two cutout switch’s in a concealed place which is hard to get to so be prepared to remove some panels. I use to put one in the ignition circuit and one in the ecu ignition live. They work wirelessly and so dose the key pad so no need to run loads of wires. The key pad needs to be on an ignition live not a permanent one.
As long as your not fitting the switches into a high amperage circuit (below 10A if I remember) there’s no need for the relays. Ideally I’d solder them in also to prevent future problems.
Hopefully that’s a little bit of help?