rich8100
Member
- Location
- dover Kent
case ih 215. Puma. We have a weaving direct drill. We are having problems with the headland not shutting the drill down on auto.
So the whole isobus and TC is working, it talks to the drill happily.
But on the headland line on the maps it will pass over the line without shutting the seed drive. It was happily doing it when the beans where drilled, but can't get it to do it. Have checked the boundary settings and the early control. All are set. Have checked the wiring on the drill. When the drill is used manually and lifted it shuts the seed off.
But doesn't do it with boundary controls.
What am I missing here.
I've tried to give as much info as i can. I've looked through ghe books and the set up is exactly as it should be.
Thanks in advance.
So the whole isobus and TC is working, it talks to the drill happily.
But on the headland line on the maps it will pass over the line without shutting the seed drive. It was happily doing it when the beans where drilled, but can't get it to do it. Have checked the boundary settings and the early control. All are set. Have checked the wiring on the drill. When the drill is used manually and lifted it shuts the seed off.
But doesn't do it with boundary controls.
What am I missing here.
I've tried to give as much info as i can. I've looked through ghe books and the set up is exactly as it should be.
Thanks in advance.