Wrapper pulling bales over.

[Greythundercloudys]

My Connor wrapper is pulling the bale over again the plastic keepers things and bursting the wrap, why do the bales on just sit in the middle where there put.

 

[Dave W]

Can you adjust the width of the rollers so the bale sits further down?

 

[Greythundercloudys]

The bales look like there sitting fine but always pulls them over, not every bale but enough to make it a pain in the ass

 

[Pistonbroke]

Are the rollers adjusted parallel to each other? Bale will move to one end if not

 

[davidroberts30]

Bales too light?
Table fully down?

 

[michael N123]

Sounds like the rollers aren’t square with each other

 

[Sharpy]

Or the bales are like traffic cones.....

 

[JamesM]

My Connor wrapper is pulling the bale over again the plastic keepers things and bursting the wrap, why do the bales on just sit in the middle where there put.

My KV wrapper was bursting bales against the green plastic bumpers, the bearing on one was shot and friction was causing it. New bearing fitted and been perfect since.

 

[ARW]

Soft bales

 

[spin cycle]

you're not having a lotta luck with your bale silage operation .....build a silage clamp perhaps

 

[Greythundercloudys]

Those bales yesterday were baled with a 3 year old mchale, so l couldnt really blame the bales.

 

[Pistonbroke]

Those bales yesterday were baled with a 3 year old mchale, so l couldnt really blame the bales.

New baler can still do uneven bales though

 

[michael N123]

Those bales yesterday were baled with a 3 year old mchale, so l couldnt really blame the bales.

Doesn’t matter how new it is if they operator is useless

can easily make bad bales if the driver thinks everything’s going to be fine just because it’s new

 

[Pistonbroke]

On our mchale wrapper the lifting arm is bent outwards slightly which means the bale doesn't always land straight in the middle. I want to straighten it but brother says it's easier to pick bales up

 

[Greythundercloudys]

Finished baling today, weather amazing, wrapper still up its old tricks.

 

[oil barron]

End things bent

 

[Greythundercloudys]

Will that belt being bent make the bale pull to the opposite side.

 

[oil barron]

Will that belt being bent make the bale pull to the opposite side.

Not the belt. The black cone. It should stop the bale going so far it catches on the belt guide.

 

[Greythundercloudys]

The first pics shows the problem, bale right up against that plastic think. It it that ripes the plastic.

 

[oil barron]

The first pics shows the problem, bale right up against that plastic think. It it that ripes the plastic.

Because it is at the wrong angle, is seized or has a burr on it.