many years ago while repairing brothers golf had had to take the gear linkage apart , heard a plastic ball from the linkage fall on the ground , ill get it later my thoughts , well i spent hours looking for it and finally had to give up and get one from the scrappy , 2 days later the dog dropped...
ravinhill get alot of local trade from firms around dyce and airport , rumblings that test holes have been dug at thainstone recently but i have not looked to see , balgownie site would have been a good purchase for ravinhill as the units would have already been built , but weve all different...
when you read the article mcgreggor indt supplies have bought it , could be a good move for them trailer wise ifor williams would be a good francize , get rid of the farm machinery and tractor side , diggers not so sure about they did seem to shift them balgownie
get your land agent to go over your poles and stays , double poles etc , if you have a pole near one of your houses feeding a third party you are due compensation for the lose of value to your house , if you want to sell your wayleave they pay 20 years in front for a deal
get the floor out , ideal time to get the underfloor heating at the same time , as mentioned above dig out sub base into level out and wacker plated , plastic silage sheet as they are nice and thick and 18" up the wall 100mm of kingspan , water pipes clipped on then a 70mm pumped in wet...
if your house is a traditional scottish house 1 1/2 story , for up stairs rooms clear off plaster and larth , we fitted 100mm kingspan between the roofing timbers on the slope again leaving room for a air gap , on the horizontal part of the roof ( the flat bit) we used doubled up glass wool ...
just done this in a 300 yr plus old farm house with uneven walls stud framing close to the wall as possible , 75mm king span on most of the wall the odd bit down to 50mm still allowing a air gap between the kingspan and wall , house now holding the heat much better now and rooms not now going...
have installed raptor here on to a new truck , spent quite a bit of time preparing the surface for a good key surface for the raptor to stick too , been all good so far , was fussy when came to spraying the liner on , not as thick as the line x which is sprayed on hot
got one here , strong gates only broken off 2 lugs off the gates in the 15 years weve had it , although ive bought some alloy gates witch i throw in now (lighter for the kids and wife to throw about ) trailer handy that you can use it to move rams and small lots with out having to go back for...
all depends if she is the main driver or not , they are clamping down on this big time, how they know i dont and in a couple of years her insurance wont drop that much because of age . better hope she does have a bump as it could open a can of worms
dont know about the north , but was over to a wedding about 15 years ago in the south , there wasnt much motors with out a bash in them , a few couples had travelled over and the the hire cars were bloody awful , racing down a motor trying to keep up with family that had been sent up to show us...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.