Just having a bit of an issue with our 7620 with it ticking over too fast, over 1100 revvs, does anyone out there know what this may be or indeed how to calibrate the throttle to try and rectify. Thank you in advance.
Hoping someone could shed a bit of light on a problem with my combine, when I put the main body in gear the low hydraulic pressure / level warner comes on the screen but then goes off almost instantly. However yesterday would not go off until you put a few revs on. Then after the combine had...
I know there was a thread about this a while ago but can’t find it. We used to grow hemp years ago for Hemcore back in the day, does anyone know who to contact about growing it again now? Would grow it for seed or straw. Thank you all in advance.
Am shure someone out there will know this to save me an expensive conversation with the accountant!
We have provided a site for a wedding in August, should we charge VAT on the rent or is it like other rents and vat free? Thank you in advance.
Been spraying some Crystal pre em and have now got a knight sprayer with most of its white bits stained a pale shade of yellow that will not simply wash off. Does anyone know of anything that will shift it? The wheels are the worst, I do like to keep my kit smart and this just frustrates me...
Hi Guys I am sure there is someone out there that can shed a bit of light on my problem,being new to any John deere myself,
I know this is an older tractor, I have acquired it for a few occasional tasks. While topping with it yesterday and today the tractor went really well until about half way...
looking at a John deere 2650 to buy for my Kv match plough, does anyone know if it is possible to get the rear wheels in to 56" centres on 13.6 r38 tyres? Used to have a ford 7610 which was tight but I fancy the John deere due to the cab position being a long way back. Thank you all in advance. Ed.
Does anyone know how to calibrate the clutch on a T7.250 ?
When under load it takes up drive very sharply, when shunting on headland it is smooth but if you stop with implement in the ground it will take up drive very sharply with the pedal fairly near the top. Thank you in advance for any advice.
Tractor Parts: Other -
Category: Tractor Parts Manufacturer: Other Price: £475 Condition: New
Description:
New Holland tractor tool box to fit the T7 range of tractors. This is a direct replacement for the off side steps and so bolts on using all existing fixings. Inside there is room for...
Front Weights: Other -
Category: Front Weights Manufacturer: Other Price: £1100 Condition: New
Description:
Weight block weighing 1000kg (heavier if specified) complete with storage compartment big enough for tool boxes,spare parts etc. The fold down lid provides a work platform and the...
Looking at investing in a program to create fairly simple drawings of component parts, ready for laser cutting and fabrication, then put them together for for fully assembled views. What are people currently using? And what would you recommend? Looking at solid works as can get hold of that...
A few pictures of one of last winters project. A bit wider, a bit heavier, a bit stronger and a few added extras compared to similar ones on the market.
Orders now being taken!!!!
does anybody know of the best way to dispose of asbestos roof sheets?? We have been asked to do a job which includes taking down an old turkey shed which has an asbestos roof and so need some help in the appropriate direction. Any advise appreciated. Thank you in advance!!!!!
Hi, am new to forum so you will have to bear with me on this!!
We have just taken on a new to us store with a continuous flow dryer unloading onto a flat floor store, just wandered if there is anyone out there that has any novel / cheap ways to cool the grain, have considered pedestals but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.