Looking at upgrading from our current Keenan 140 to a twin tub and want to beable to feed all the milkers in one batch approx 170 cows. So think we’re looking around the 21 cube mark. Will have to be a second hand machine ideally that’s been refurbed. Any makes in particular to look at or to...
Been having a look through Google with little success, but looking for a replacement lever for our siloking wagon. They are bondioli & pavesi levers and seem to be the only type I can't find. Alternatively a replacement 2 lever block that would work with the current cables may suffice
We have a Shelbourne reynolds mixer wagon its about 9 years old, in good order overall, conveyor good etc.
But as with many its getting thin in places, im happy to plasma cut some 4mm or 6mm plate to make a second skin for it, but the augers could probabaly do with some wear plates, can you buy...
Written by Justin Roberts from Agriland
The precision feeding of cows is now very much science-based on the tremendous amount of research that has gone into ruminant nutrition over the last century or so.
For the greater part, this has naturally focused on the functioning of a cow’s digestive...
Never had one before, always mixed maize and grass at the pit face with telehandler, cake fed to yield.
Grass silage in short supply, so want to improve fibre in winter ration by adding hay or straw to maize...
Where to get a sensible side chute mixer wagon? Which ones are reliable? Any...
Hey
Need some help. So we got this Siloking mixer 2018 year model, and we want to know if it's possible to get the seat sensor to stay on even if I'm not sitting in it. The dealer says it vmcan only be done by ECU but I suspect the just want some easy cash. Kinda tired of lifting a dunbell onto...
Evening,
I’ve just started out using a new to me kv silo king duo 22m3 twin auger tub mixer, and I’m having a few teething problems.
First off, on a small mix (1500kg total, 1t of maize silage, 250kg of rolled maize 100kg of blend, 150l of water) it won’t mix properly as it doesn’t cover the...
Written by John Swire
The Kverneland Siloking self-propelled feeder range has been extended with the introduction of the System 300+ model in the SelfLine 4.0 range.
This new version represents the smallest SelfLine 4.0 conventional-chassis machine currently available from Kverneland, and is...
I'm coming from a place of zero experience with this so I'm hoping some people on here with experience can help:
I'm planning on upgrading my feeding method to use a diet feeder. The only problem is that most of my loader work is done with an old JCB 3cx or a NH 7740 with front loader, so I...
Looking for some opinions
Recently bought a small diet feeder fir feeding bales out to our cattle and sheep, so far going grand except that the tanco bale shear we have got is not working in that despite being 4 or 5 foot above the feeder often the bale turning on the tub seems to grab the...
Our current shelbourne vertical diet feeder is about to give up!
We are looking to change and I was wondering what people were running and what recommendations you were willing to give. It would be a single auger and a 15cu we are looking at.
Any suggestions greatly welcomed. TIA.
I’m looking for options when it comes to low cross conveyor discharge tub diet feeders. We’ve a 12’ central passage that we feed down both sides against a 40-50cm high barrier. So I usually end up with a small amount straight through the feed frame and into the muck if a big lump comes out or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.