I had nowhere particularly nice or convenient and I didn't want to drill holes. I think a foot switch would be better and I might add one but in the meantime I used a small enclosure and some strong sticky hook and loop tape.I've got all the software up and running and have an RTK signal now just waiting for the Baraki valve to arrive.
Has anybody got any recommendations for a neat switch to turn on the guidance? Looking for one to fit where the front PTO would go on a JD 7530. I'm thinking it wants to be a normally open momentary switch?
Could have used the factory engage button on the panel ?I had nowhere particularly nice or convenient and I didn't want to drill holes. I think a foot switch would be better and I might add one but in the meantime I used a small enclosure and some strong sticky hook and loop tape. View attachment 1179768
Yes, that would be a good solution but I don't have the knowledge how to go about that just yet.Could have used the factory engage button on the panel ?
I'll ping you a firmware for it later - CANBUS for the panel is on the rear pillar.Yes, that would be a good solution but I don't have the knowledge how to go about that just yet.
From Load pageHow to delete this field?
Or in windows explorer. Delete the folder or move somewhere for safekeeping to de-clutter AOG.How to delete this field?
Where is that?From Load page
Thank you. I'm already plugged into the canbus so is it just an update/upload of the firmware that I need to do?I'll ping you a firmware for it later - CANBUS for the panel is on the rear pillar.
Have you got two plugs?Thank you. I'm already plugged into the canbus so is it just an update/upload of the firmware that I need to do?
Yes, black and green and I'm plugged into both.Have you got two plugs?
Which board do you have? And what tractor/age?Yes, black and green and I'm plugged into both.
I think it's a V2.5 board, 2018 case maxxum tractor.Which board do you have? And what tractor/age?
Dont start about mowersset mine up measured everythingProbably been asked before but What off-set should I put in for front and back mowers? 3meter front and backs.
Thanks
Probably been asked before but What off-set should I put in for front and back mowers? 3meter front and backs.
Thanks
Offset 143cm right, 586cm machine width then 10 to 15 cm overlap. Tape measure to confirm when mounted, mostly for the front/back overlap.Probably been asked before but What off-set should I put in for front and back mowers? 3meter front and backs.
Thanks