Toolbox for to fit CNH for sale

The toolbox I built for my 59 plate Maxxum 140 is for sale after selling the tractor and getting a puma in it's place, no idea what I am going to do for tools on the puma yet but this won't fit.

It doesn't look as shiny now after a few years use. The bracket for the drawbar isn't included as it has gone back on the step. It's not 100% water tight.

Open to offers.

 

[Badshot]

Sold pending payment.

Thanks for the interest.

 

[Badshot]

If anyone is interested this is for sale again due to the buyer changing tractors before collecting it.

 

[Daniel]

How much? Not sure it will fit mine with the adblue exhaust stack taking up more room? How easy is it to remove to get at the battery?

Toolbox size and cab storage leave a lot to be desired though.

 

[Badshot]

That won't fit yours Daniel, I have had a nice one made for my t6, goes where the original is on top of the fuel tank.

 

[Daniel]

That won't fit yours Daniel, I have had a nice one made for my t6, goes where the original is on top of the fuel tank.View attachment 59625

Very smart, the original one is tiny!

 

[Badshot]

Pathetically small, that wasn't too expensive.

 

[Daniel]

Pathetically small, that wasn't too expensive.

Who made it?

 

[Badshot]

http://www.truckware.co.uk/acatalog/Steel_Toolboxes.html

Was this lot, good service with the two I got off them, unfortunately TNT managed to lose one of them but it turned up eventually. They will make any size and to be honest I think I'd do mine differently now, a bit narrower and have the door facing the side instead of the front. (I haven't looked to see if the handle will get in the way though so don't take my word on that) I had mine done with a shelf halfway too, might change that to two thirds up possibly.

Good steel boxes IMO.