Recent content by AWJ26

Send them both to superior to skim and groove them, i did our last 700 many years ago, improved output and far better sample. The dimples are intended for green crimp to pull it through, but the scrapers soon wear the high spots off them. My 700 with grooved rollers would do 14 tph on triticale...

We have had them for nearly 11 years, cows in 365. Wouldn't have them again for our situation, they are only about 20mm thick at the back end now, several have been replaced that wore and holes/tears appeared. BIGGEST pain is the metal cover strips between the mats. If you don't have them...

262205 Yoke, Hub, 50x50mm, W2600/P600 Walterscheid Kramp sell them.

Drill a couple of holes one end of the conveyor belt and attach a loop of rope. You can then hook them off with a tine on the grab and lay on a pallet when feeding out the silage, and makes them a lot easier to handle when covering the pit. Drilling all the holes would be a good job to keep an...

I've got a pre isobus amazone sprayer with an Amatron+ screen. Can I link it to an agco C3000 screen in a massey and control the sprayer with the C3000? I've seen a video on YouTube with a topcon screen doing this. If so, can you tell me what cable I need. Thanks. @Northern farmer

Was thinking about continuing the mats into the passageway which is not slatted.

We have cowcare rope scrapers that scrape onto slats in front of the robots. I'm wanting to put slat mats down to help with white line as cows always seem to bull on the slats. Has anyone successfully got a scraper going from concrete passage up onto slat mats without it jamming or damaging the...

Did you ever sort this out?

We changed from biolac to Gea luxspray 50 and big improvement. Recently changed to MVF 0.52% iodine made by diversey. So far, so good- MVF's is £665 for IBC, Gea was £1050. Iodine definitely works better for us.

No, sold the tractor before we got round to fitting the air brakes.

First 2 A4's been in 9 years, installed a third second hand one this February. Only call out this year was to commission third robot. Wouldn't want to go back. I visit many dairy farms crimping and crushing grain during the summers and see too many older dairy farmers who are worn out from years...

A4 doesn't mix the brush cleaner in the boiler. I connected the heat recovery supply straight into the boiler inlet, no extra valve needed.

The Lely techs use SAS for degreasing the air cylinders on the robots. Combine that with their strawberry vape, and it's quite a heady mix!

Sounds like speed sensor, don't unbolt the sensor, you can unclip the middle and replace with out losing any oil.

There wouldn't be enough room, they are big diameter.