ccp contracting's latest activity
-
ccp contracting replied to the thread R38 vs r42 speed difference.I think a 650/85x 38 is bigger than a 650/65 x 42 , i think you would need a 650/75x38 -
ccp contracting replied to the thread Spring Barley.Planet spring barley claydon straight into wheat stubble last week of March , the thin rows are wheelings from rolling tractor.
-
-
ccp contracting replied to the thread Spreader plate..Finally got out again after adjusting the splash plate as suggested all good now , thanks for your advise.
-
ccp contracting replied to the thread Massey Ferguson load sensing issue.On my 7720s using the forage waggon when ever you opperated the pick up the suspention dropped , found there was a tap on the waggon...
-
ccp contracting replied to the thread Spreader plate..There is no curved band on it , just the flat plate , looking at now it looks like the plate is set to low compared to the cone ,thanks...
-
ccp contracting replied to the thread Spreader plate..Here is the splash plate set as it can go , the next picture does not realy show how bad it is .
-
-
ccp contracting replied to the thread Spreader plate..The slurry is not thick and the cone has not been cut back , i was woundering there was so much tank pressure , thanks for your thoughts...
-
Can any one help , using a spreader plate on the tanker it is leaving masses of slurry abouta meter wide on the outside of each bowt ...
-
ccp contracting replied to the thread Useless air brakes on mf 77s tractors.On my 2018 MF7720 air brakes are useless on a Stewart trailer ,on NH and Valtra the Stewart air brakes are briliant.
-
ccp contracting replied to the thread Loaded up and trucking!!.I think its a garage at a place called Prats bottom on the A21 a couple of miles inside the M25
-
ccp contracting replied to the thread Loaded up and trucking!!.Where is the picture of the Clock Garage it very similar to a garage near me from years ago .
-
ccp contracting replied to the thread Mf 187 baler.Try running on powerbeyond , if big bale have been through it , it will be ok.
-
ccp contracting replied to the thread Lamma 2024.I found the number marking for the stands was terrible couldnt work out where the stands were that i wanted to see.
-
ccp contracting replied to the thread Robot feed pusher experience.A farm i relief feed on had a lely juno , did do a great job but often got lost going round in circles in the yard ,anyway made me...
-
ccp contracting replied to the thread 4m drill price.My neigbour bought new Hosch Avatar 4m , 2 years ago £80000.
