Recent content by Earnacrust

2 JD 6010's, thanks

Could do with a js 130 moving between st17 and sy21, ideally on a rigid . Thanks

Is that homemade? Good solution if your not using a weight block very often

AHH right that makes sense, will try that later. Thanks

I'm after some advice with this system,. I have got to grips with it mostly just struggling to get the map to show work done. Have tried using different triggers, must be something obvious I'm missing?

Just covered a thousand hours on a 7718, as you say the lock is surprisingly good as is the suspension, especially compared with the 76. Ours is a Dyna 6, drills with a 3m rapid, lots of haulage work. A big improvement over the 76 which we also run. It's not had a spanner on it, pulls well and I...

On behalf of a friend: Organic round bale hay, certified, 500 bales available, discount for quantity, in Leek Staffs. £22.50 a bale. Contact him on 07974755110.

Try a different web browser, if your on internet explorer try Google chrome or Firefox.

Don't mean to go off topic but those of you sowing grass with the vaderstad and are not under sowing or direct drilling, say after maize, how do you stop it coming up in rows? I thought about leaving the two leavers that are used during calibration so the seed is sprinkled on instead of going...

Cultivators: Simba - Toptilth Category: Cultivators Manufacturer: Simba Price: Open to offers Condition: Used Description: Simba Toptilth. 3m. Been converted to work off the linkage, also has the original press wheels to replace the coil at the back. Needs some new points, may have a few in...

Cultivators: Dowdeswell - Discs Category: Cultivators Manufacturer: Dowdeswell Price: Open to offers Condition: Used Description: 2001 4m Dowdeswell Discs. Good working order, Well maintained. Viewing welcome. Images: See the full size images for this listing on the classifieds by...

The c3000 so the older ones.

Hard to find much info about these drills. Currently run a vaderstad but see the Kuhn runs a similar cultivation setup to the new Vaderstad with the levelling bar right at the front but the seed coulters are behind the tyres cant decide if it would make it a easier pull or better in the sticky...

Should go, you just need to put it on the outside section on the bottom pulley first then work the belt across the pulley obne section at a time top and bottom, wedging a chisel while rotating the pulley will keep moving the belt over each section just mind your fingers.

We pull a set of 4 meter dowdeswell with 150 hp, they are for sale. Your more than welcome to have a look, not to far from you.