Recent content by MickW

It’s probably worth more than the poor old gal

You need to look at loaded rolling circumferenc, you might be surprised.

Not sure if these photos should go in wreckers or here. Crying shame spotted recently while on the North Coast 500 it’ll take more than WD40 and T cut

Is it not simply a slip clutch not an over run clutch? It would take a hell of a force getting it to slip in the vice. The only option is a strip down and clean up or renew it

Intermittently you say, make sure the lift arms aren’t at the top I can’t remember why but they need to be slightly lower than maximum to allow the external flow. Does that make sense?

not old really but time to think about the future and do something while you can. I retired at 63 (71 now) and faffed around until wifey retired we decided to travel both UK and abroad and spend some of our pensions etc, so far loved it and should have retired earlier (1968 would have done) you...

hi I own a VW T6 and I find the T6 forum really helpful i believe that theres a dedicated T5 forum. There’s a lot of VW knowledgeable people on it along with a few strokers, worth a try

I tried to clean my 4000 tank by various means rather a pain in the —- I fitted a pipe into the tap which lifted the level which worked for a while, but I eventually fitted a new tank problem sorted. Should have fitted a new tank at the start. when I tried a pressure washer it cleaned a lot of...

801

I started work as an apprentice 8th August 1968 for a Ford Ransomes dealer during the first week I accompanied one of the service guys out to a Ransomes 801, the front pulley on the engine had worked loose and damaged both the crank and the pulley the mean old farmer had us bodge the pulley back...

https://nwtpc.co.uk/shows/ Far from died out there is a European event in Garstand Lancs later this month

A bus bar is normally bolted rather than plugged so can normally take more power, you could buy a JD plug one and install it. just look for 12v Busbar

The mojo 3D is capable of being used as an update on an old Mojo Console re Michael above however it can be used as a stand alone unit with options for steering etc. Pinpoint offers support in the uk 07551 908595 and I believe Spaldings are resellers

The 3D can be used for steering and mapping it far more advanced than the old Mojo console which Michael mentions. Support in the uk is via Pinpoint below, I believe Spaldings are still resellers

I’d find an old carpet and use it for spraying on try and keep it fairly clean recently sprayed a car body on an earth floor, really helps keeping the dust down