No we have a 120 litre hot water heater which heats to about 75 c from the heater it run through a thermostatic mixer valve with a cold supply delivering water to the mixer at around 42c it sounds very elaborate but it was all bought off eBay for a few £100
We have a 170 litre Jfc with mixer with dispensing gun fed 60 calves tonight 39.8 c when I started the last milk out 37c all done in 26 minutes. A brilliant bit of kit no more mixing and carrying buckets the display says 76k litres in 12 months but 15% of this would be washing out we had put 11...
Alex Lawrence 07775445966 Dipped for us last autumn very good with sheep all went very smoothly based in alensmore so would probably be the most local.
The baler won’t turn over because the tips of the needle s are still in the chamber ,if you pull them out by pulling by hand on the frame they are mounted on this will lower the ram stop out of the chamber then turn the flywheel manually for a full cycle to check the needles stay out of the...
I did Drayton calves this morning as well 100 miles each way watched the first 200 sold and didn’t get started truely mental had blue heifers delivered in this afternoon for 50 a piece less
Thank you both for that I did wonder if that was the reason as the intermediate only has 39 teeth not a even number. And yes the crank is well chewed on No1 journal hopefully it can be ground. Thanks again.
I’m in the process of taking the crank out as the big end shells are gone on No. 1 cylinder. When I took timing gear cover off I checked for timing marks on gears and with No1 at tdc the marks on crank cam and injection pump gear were about where I expected them to be but none of them lined up...
I’ve been having issues with the existing radio in my 7726, and wanted to change I usually do this in all my tractors with little bother, but for some reason I can’t get it to work in the Massey, I cannot save any memory settings in the new radio as the automatic isolator cuts all power to the...
Ok so I’m looking to build a setup like this, where do I start, I’ve found a lot of different parts lists and was wondering if there is a standard one to get going and using the ardusimple rtk receiver setup with it, starting out is it best to buy the parts and put together with breadboards or...
Been looking at doing this myself, out of interest what system did you use to get rtk setup? I’ve seen the Emlid reach receiver as a good start point but was wondering if there was a different way?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.