Recent content by Sebastian77

  1. S

    Easiest hooking on or off front and rear mowers?

    We've always put a short length of 4x4 below the center "arm" on our novacat, then when you lower the link arms the weight comes straight off the headstock. Without it even if you lock the headstock off it will still keep dropping down and make the job a right pain in the ass
  2. S

    Steering ram inner tie rods

    You'll be surprised, we fitted new track rods and joints to our case, and they would continuously unscrew themselves out of the ram, so had to locktite in the end.
  3. S

    Young farmer killed in bale-wrapping machine

    rubbish to that, get a few sheep 😂
  4. S

    Young farmer killed in bale-wrapping machine

    I'm IPAF trained so just to say. You would never use a safety net under a Scissor lift (physically impossible), and wouldn't use one under a cherry-picker style lifter either. In terms of the law, a Scissor lift does not require any fall restraints. Cherry-pickers or man-cage require a fixed...
  5. S

    Sheet your load.......

    My interpretation is that if the load (grain) level is below the sides (at the highest point), then no sheet is needed?
  6. S

    Tedder/rake wheel/tyre assembly. 16x6.50-8

    Think we've been using wrong dealer 😂
  7. S

    Tedder/rake wheel/tyre assembly. 16x6.50-8

    We've tried in the past to buy them direct from Pottenger as run their tedder and rake, and same size tyre on the McHale baler too. Never managed to get any 👎. Reminds me to look on ebay for this summer..
  8. S

    rea valley

    Sharmans are barely any further away than startin, and only took on Case in last year. Then Farmstar at Newark also.. That would be 4 Case dealers in a 40ish mile area..
  9. S

    CASE 5150 Powershift problem

    Will most likely be 2nd gear pressure switch, BUT I will say, we had another 5150 (non pro) that spent it's entire life with no 2nd powershift, tried everything to fix it but eventually gave up and just drove around it (suspected was the clutch pack for that gear but never had time to split it...
  10. S

    CASE 5150 Powershift problem

    @ACEngineering Got one for us last time.
  11. S

    CASE 5150 Powershift problem

    can almost guarantee it will a pressure switch on the transmission, whenever you select that gear it faults and get no drive. When it happens if you dip the clutch and hold it down, the orange transmission light on the left of the dash will flash, think it's like 5 times. very common on these...
  12. S

    Air con pipe jd 6910

    If it's the same as a 6900, seat out, panel underneath unscrews and remove. Whole area will be absolutely filth so good time to clean it all out
  13. S

    Alliance tyres unbelievable customer service

    Just to sprinkle some positive vibes, had a set of 420/85R24 agristar2 from Terry a few years ago and have been great tyres on the front of our loader tractor, used every day for carting/stacking/feeding bales
  14. S

    how do I get Case hydraulics to pump continuously

    They usually have a little latch, or something you pull over to lock the spool in flow. Free flow return is best. No need to lower the flow unless it's too much for what you are running. For example in the summer our wrapper can be running off a spool for 6+ hours a day
  15. S

    Trailer rams cock up

    Rub the rust off till smooth with emery cloth, rub a bit of oil on after and you'll be good to go.
Top