Search results

Got into tractor this morning and when I put the lights on the hazard lights came on too. Has anyone had this before? Light switch and hazard switch are next to each other so maybe a wire shorting? Any suggestions would be appreciated before I start taking the dash apart. TIA

I have a problem with the hydraulic circuit for the boom attachment on JCB 526 with all lever controls. The circuit is switchable to the pickup hitch which is working normally. The attachment however, the oil flows fine in one direction but when the lever goes the other way it locks up. So you...

Free advice is being offered to the cost of £1000 (that’s one day of advice apparently) to explore the impacts of direct payment reductions and to develop structured change management plans. Personally, I can’t see the point and resent the fact that government money is being spent so freely on...

I need to replace the wiper motor on my old Deutz. Does anyone know where I should be looking in order to not be ripped off? Thanks

Anyone know what laid these eggs on newly emerged rye seedling in cover crop?

I am really fed up with the BBC’s agenda. Everyday there is a news report about meat being bad for you, farm livestock being bad for the future of the planet etc. etc. Yesterday it was the UN report that we must all stop eating meat to stop global warming because livestock production is...

I'm not generalising, but I've just been around my wheat crops, earliest mid October drilled Skyfall, latest early November drilled Cordiale, and on dissection have found the majority of leaf3 still tightly rolled up inside leaf4. Given the cold weather this week and that I only got 2mm of...

Quite a bit of yellow rust in November drilled Cordiale. Will get T0 fungicide this week. Are others seeing much rust yet?

Hi there, had a problem with the low pressure hydraulics to engage the threshing mechanism. The fault is in the electrics as not getting any signal to the solenoid. Have checked all fuses, swapped relays and visually checked wiring. Have a voltage at the switches but don't know what to look for...