Search results

Thanks for that I did it, oil cold at idle steering pressure 2200 psi and load sense 2000psi that was with a new steering unit but at that stage was old priority valve. They said the pump tested 3000 psi and 60l one would hope the flow was tested at 3000 psi by the dealer. Have you ever seen an...

I am open to suggestions but I have listed what has been done and what has been replaced. Not leaving too many more things to be faulty is there? Nobody seems concerned about aerated oil or checking oil pump /pickup. I have put the post out hopefully in an area where there is plenty of them...

Checked steering cylinder at full lock with one hose off no bypass. steering does not wander.

Dealer checked flow I take would have been at remotes ? . I was not there. they said 60l but supposed to be 64l. I would have thought that would be acceptable? .

the steering now wherever you leave the wheels turned while driving is where they stay. oil was full but with testing and replacement of parts it is on the low mark at the moment. no one has ever had a pickup pipe crack or dislodge partially

Was checked by a very expensive dealer. Does not matter weather wheels are on or off the ground, Using hyguard oil. Can use remote or 3 point linkage while steering no change. So is it ok for the oil to be frothy in the sight glass. Should I be looking at the pump / oil pickup. Oil pick up...

cab tractor only 2000 hours no that's free

My steering recently become heavy over a period of 2 hours. Extensive testing by John Deere showed no problems. They then started telling me to replace parts. I have replaced the orbital steering unit and priority valve. I believe that it may be airated oil causing the problem. Nobody knows...

What is a dime valve. The load sense line from steering unit goes into the priority valve which has been replaced. I am not aware of the brakes altering the steering if applied. I am led to believe you have plenty of these over here. The oil is very aerated in the sight glass could this be the...

My steering recently become heavy over a period of 2 hours. Extensive testing by John Deere showed no problems. They then started telling me to replace parts. I have replaced the orbital steering unit and priority valve. I believe that it may be airated oil causing the problem. Nobody knows...