Search results

It's an 2001 model. Electrical agroshift with two buttons, rabbit and turtle. Two solenoids. IT happens the warning lamp for the hydraulics lights when shifting. Do not have any reader for codes.

Hi, I have som problems with the Same Silver 100.4 Agroshift - hope someone may help... I have had a bit bad response on the hydraulics, so I've replaced both hydraulic pumps. And the Agroshift Low didn't respond, so I've replaced the solenoid and cleaned the husing where the Agroshift...

Hydr.oil and filters changed in april. And filters replaced again in august - hydraulic pumps was replaced then. The Service-lamp did light up sometimes when shifting to L before that, but the Agroshift worked fine.

Thanks. I did get a manual from SDF. Appreciate your tips. I'll check the power and earth first. I guess the lamps in the panel indicating HML lights as usual. And also when I press the button for L the lights for Service often lights up for some seconds.

Hi I've cleaned the plugs I found and I can't find any bad connections. It's not better. What to check next?

I think I found the wires and plugs. I tried to disconnect and reconnect one of them, and then it shifted. It seamed ok at the beginning, but after some shifts from lower to medium it startet to not engage properly (don't know the correct word...).

Looks like the SDF store is only for Italy by now.

Ah. Thanks. Agroshift! It's stuck in medium range. It has been doing this for å couple of weeks. First it started to engage and go back to medium range for for some days. I'll have å look and hopefully locate the HML valve block. By the way - do you know where to get a "repair-handbook"? I...

Hi all, I have a Same Silver 100.4 and the lowest gear on the fast shift (?) has stopped working. The middle and highest on fast shift seams ok. But when I try lowest nothing happens - just changing the light indicator. Anybody know why and how to fix? Regards Jon

Thank you for the description. I had a look today, but didn't see the pumps. Guess a wash will make it better :-) From the descriptions the pumps may be above the filters?

Thanks!

And by the way - one pump is for the steering and one for the rest of the hydraulics originally? Or steering and front loader on one pump?

Thanks. I'm going to replace oil and filters. But because of the noise I wanted to locate the pump to check if the noise is from it.

Very bad pressure. And I think, from the location, that it has also started making a noise.

Thanks. I'll dig in - or wash and look. From the net shop the pump look like this: (?)

Covered, or should I see them without removing anything? I looked up new pump on a net store to see how they look, but couldn't see anything alike behind the fuel tank...

Hi, May someone help me locate the hydraulic pump on a Same Silver 100.4?