Search results

Yes I agree with you there. I'll give Nick Youngs a shout tomorrow, I do find them very helpful. I'll send them some pics and see what they say.

Local parts place took a month to get parts last time, even though I called once a week. Finally parts arrived they forgot something and then said sorry about that I've ordered it today and it'll be here tomorrow. Nothing extraordinary parts wise either.

I got the bearing kit and spindals from Nick Young tractor parts

I have had the spindle housings repaired as the new bearings would have just fallen out as there was 1.5mm of side play due to loads of wear. My problem is that the new spindles and bearings look as if the spindles should sit in a stepped bearing to spread the load. And also the lock stops are...

I'm not sure now as I have had tyres fitted, and I can't remember what size they are now either.

I haven't got the wheels and tractor in the same place, I have another problem to deal with first. I need to get the front axle spindles refitted.

Yes that is a brilliant point, the answer is no. 🤣🤣

Any idea where I could get some countersunk washers for the wheels? Are there tractor specialists that stock them?

This is the one, someone took some footage of it.

They have it stickered as a 1630 but the guy that sold it to them told me it was a 1030 I think when he checked his records when I mentioned where I got the loader from. The young lad that has it said John Deere did them in mechanical then hydraulic drive then back to mechanical again.

I bought some rear guards from Nick Young and a roof, I'll have a look though as interior trim will be needed too. I have bought a loader for it but it came off a 4wd 1630 local to me. The tractor came from somewhere in England and was bought without a loader, The loader I have for it is a...

Super! Thank you..

It's a bit dented. You can still get new front ones. £16.50

Hydraulics work ok, no Hi/Lo. I have fitted new pin and bearings to do with the bellcrank and axle pivot. I didn't realise roller taper conversions were a thing for the bellcrank. I am having the spindle housings repaired, why fit new bearings when you can use the spindles as bearings. Poor...

Wow! Thanks for your input guys. After spending days of filling and sanding I hope they fit. All I know is I should have tried them first before painting but I had a small window for getting them sandblasted and painted. So they should fit my John then? Any idea of what to do wheel nut/stud...

I bought these from a local John Deere supplier and was told they came off a 30 series tractor but he wasn't sure what they were originally off. Can anyone identify them? ignore the colour. PCD looks to be the same as J/Deere, I haven't tried them yet!

Tractortech here you go

I think like Tractortech says the butyl would be best so I could still remove the windows if I break one. Thanks guys for your suggestions .

An OPU cab

I'd love to see your hill starts. 🤣🤣🤣