Search results

Looking for transport a Landover from mid Wales to Portsmouth ,

I got a parmiter post thumper .old but does the job.needs a new chain to lift up the mast.where do i get one.cant see a marks on chain at all

Ok folks seen a very clean hilux for sale. Two yr old 21k miles. 3 yrs warranty left.what r they like. Only the base model.but seems well specked. But only 2.5l .should I go for a 3l or avoid Toyota altogether.ps 7 k saving from new

.

Any one got a good system for sheep shed feed passage barrier. That doesn't cost too much. Stops sheep getting out or climbing through.and simple.

What would work out the cheapest .20 foot bays against 15 foot. Less steel but bigger purlin s And long and narrow say 160 by 40 in 20 feet bays or 165by40 in 15 bays

ok folks, thinking about a system on the ground. farm not on 3 phase. but a 3 phase line goes through farm. can place system within 50 metres of nearest transformer and buildings. 100 metres from meters etc. however we dont use a lot of electric atm. would a system pay, funds available to...

anyone coming home empty small trailer to get home

anybody know what make the wheel hubs and brakes shoes are. mine are wore out ,and i cant see no makers marks upom them

Any body like to recommend a little printer to link to my hand held tag reader .thats farmer proof

i have made a lamb milk feeder, holds 5 gallon inside a insulated wheelie bin.holds steady temp. just like a thermos flask, what do folks think best temp would be. i have a fishtank heater thats 100 watt. and goes up to 30 degrees. not tried in it yet. as temp only drops one and half degree a...

any one got one of these towing. top end model with all the bells and whistles but without rear leafsprings . has coiled springs instead . got a chance of a ex demo . big saving to be had ,but its a automatic. opinions please.

Whats a ball park figure for a typical set up.what size number and cash needed. And am i opening a can worms

I have a circlip flying off a clutch cable. its only 8mm internal size. do you folks reuse them ,or replace. and how can you tighten them up.

wanted weed wiper ,wick.or brush or carpet

anyone know what the going rate is for copper pipe cut up with all the brass bits separated. got several licking lips at it. needs going soon before its pinched

I am aftersome fancy pheasants reeves, melanistic ,mutants ,white. golden ,amhursts jap greens. to keep. not to shoot. just as a hobby. any one out there.