We have a Valtra n121. There is Error showing up when ignition is switched on, C297. The tractor will start but the stop light is flashing plus the engine oil pressure light is flashing but at a slower rate. The engine power debated. Engine oil pressure tested and good. We think that the fault...
Small update on testing the brakes. When the two brake pedals are connected together they go to the floor. Separate them and right peddle goes to the floor but left peddle works as it should. This would indicate that there is some issue around the pedal box/master cylinder part of the brake...
thanks, Is there a check valve in this older design, similar to the newer accumulator setup? Is there any debug / diagnostic that we could do to figure out the issue?
Hi,
My brother just bought a 6920s John Deere with a few small issues. The main issue is the brakes. The brakes reasonably ok when engine running (maybe slightly hard on the peddle). When engine is switched of with your foot on the peddle it can be pressed to the floor (no brakes at all with...
Hi,
My brother is going to split the engine and transmission on a Valtra T161 as there is oil leaking most likely from the crank shaft seal. As this is the first time this is being done, are there any hidden gotchas or issues that he might run into doing the job?
Regards
Tom
OK, Some further testing done.
Measured the pressure at the outlet of the pump and measured 150ps.
Measured again at the test port and got 50psi.
Removed the oil filter and the pressure out of the pump dropped to around 60psi, raising a bit when engine revved but nothing much.
From this is...
Thank you for the link to the previous issue. I should probably have described the movement as creep initially up to the point that the clutch plates had to be replaced due to this. After replacement of the plates, the issue has gotten worse and is now more like lunging. We will be checking the...
Hi,
I am trying to sort out a strange problem with a power quad gearbox on a John Deere 6620 tractor.
When the tractor is put into either A,B,C etc gears it lunges forward as if the Forward clutch is partially engaged. Due to this problem the forward clutch eventually failed and the clutch...
Latest measurements before the pump was stripped indicated that pressure was down a little but flow was down a lot. Tipping a trailer was quite slow and the steering worked ok when turned slowly but nearly stops when trying to turn fast. The broken bearing in the pump would probably prevent the...
Small update. The Rexroth pump was removed from the tractor and opened to find that one of the saddle bearings on the squash plate was damaged / partially missing. Not sure where the missing pieces have gone to :) I will send on a photo of the bearing later
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.