Search results

Did you ever find the problem with it I have no light on the dash now either suspension is up but not over pumping I can't let it down or up on the switch seems more of a power problem than hydraulic

Brakes arnt great sort of all or nothing with them the master cylinder cracks inside other than that very good machine if you take the time to find out the settings to suit you

A sure look we are all in the real world it's not all by the book

It's at 3 leaf stage now ground is holding moisture at the min. Heavy rain for Sunday and Monday and temps good during the day so it should keep growing on . I'm collecting the spray tomorrow an agronomist was out looking at the beet and had a look at it and said this spray was banned from...

I can read the label more about how soft the grass is should I wait longer

Reseed sowed little over 3 and half weeks absolute full of docks how soon could I spray for them no clover in grass it's a rye grass mix around 3 to 4 inches high Thanks

No pedal wasn't pulsing just had a cracked master and no brakes when engine was off. I had oil coming through the accumalater too

I know yous said 9 bar and it came with 8 maybe it's 8 now to prevent them failing although on the side if the accumalater it says 100 bar max pressure so should be good . How was it charged I don't see a one way valve only an Allen key bolt and when this is open you look straight down into it

7465 same issues as yourselves for the past year were told that's the way the brakes are . No real feel and harder pressed than youd like but I do reclaim steep hills one day she stalled driving a stone crusher and had no foot brake also last summer she started leaking into the cab which was a...

I think that was the fault code that came up on our 7400 series it was for blocked trans filter so if say your wire of a sensor is showing that

I know this is an old tread but I am just wondering is the part number you listed correct for that accumalater I took mine off today but can find that number on it thanks

Anyone any suggestions on the settings for bale density on a 255 claas baler seems a half turn back is making d bake to early and looser than just less than a quarter turn back

Thanks. The back door dosnt move a milometer as far as I can see I don't think it's supposed to give I used to have a 46 and the back door used to open if you didn't keep pressuring the back door something to do with the hydraulic block got a new one and stopped the door opening. when I turn the...

Have just got a 2005 claas 255 rc and cannot figure the correct density settings a lad who has one said you wind in the knob adjuster on the hydralic block to the last and then out a half turn but the auto netter was goin of to early even before the bale is fully made. I turned it back roughly a...