Search results

It’s cheaper to collect in bags than get it put in a bin, the mill is only about 5 miles away.

Second load of sheep cake this lambing. Not looking forward to the paying the bill next month.

Thanks

Just wondered what posts are been used and who’s are the best. Fed up of posts not lasting

Seen the first swallow today. North Lancs

Just a comment on the 3 stoves you’ve looked at, go with the Woodwarm they are the best both in quality and and customer service. We’ve been selling their stoves for over 40 years. Their gas stove is one of the only ones that is fully remote controlled.

Thanks for sharing, did you meet a pilot called Vicky, she’s my next door neighbour.

We got a Jasic, it’s been sent back twice in first 18 months because of problems. It was repaired with out any hesitation. I’d have another, it welds very well.

We use stainless threaded bar and resin for bolting our crush down. No problems undoing nuts if needed.

I used artic axles and bought the suspension from Granning. It’s rated at 21 tonne gross I’d 15 tonne of fert on without any problems.

I used 8mm, it may not be much different in cost to build your own but there’s more satisfaction in building your own than just writing a cheque to some dealer. Well that’s how I justified it.

We changed to Caisley 3 years ago, very few replacement tags with with our suckers and they are very helpful when we do ring up. We won’t be going any where else for tags.

Try Bill at Cumbria XPress, Penrith

Have a look at the Woodwarm Firegem or Fireblaze. Knock the spots of Clearview.

If your looking for the most reliable stoves, that are British then go for Charnwood, Dunsley, Town & Country Fire and Woodwarm. They may look expensive but they are all well made and efficient. The spares will be available in years to come, long after machine mart have stopped selling stoves...

Steel and parts only, labour’s free isn’t it....!!

Just under 6k including about 6-7 packets of welding rods.

I’ve just built this over summer, 24ft, commercial axles and 560/45 tyres and used Granning suspension

Thanks, we’re going to get it done properly. One of our customers is a blaster and told us we should put a polyurethane top coat so that it lasts my life time.

These are as the job was going on