Forums
New posts
Forum list
Search forums
What's new
New posts
New resources
Latest activity
Trending Threads
Resources
Latest reviews
Search resources
FarmTV
Farm Compare
Search
Tokens/Searches
Calendar
Upcoming Events
Members
Registered members
Current visitors
New Resources
New posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Forum list
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
Farm Machinery
Machinery
Krone mower bed problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Dave W" data-source="post: 8147290" data-attributes="member: 643"><p>Done these type of gears a few times. They press out quite easily and the wire just breaks into 2 or 3 bits. </p><p>Buy a set of bearings as posted above with the wide circlips. Throw circlips away and re use the largest pieces of the original wire (assuming you can't get new wire clips). Clean everything up well first and re assemble with some loctite/bearings fit and the wires but straighten the wires a little first so they have a bit of extra spring.</p><p></p><p>I press the bearings in using vice. Sit the wire in the bearing groove and press in until the wire just starts to nip. Then tap the wire down with screwdriver and it will pop into the gear nicely. Easy one you get the knack</p></blockquote><p></p>
[QUOTE="Dave W, post: 8147290, member: 643"] Done these type of gears a few times. They press out quite easily and the wire just breaks into 2 or 3 bits. Buy a set of bearings as posted above with the wide circlips. Throw circlips away and re use the largest pieces of the original wire (assuming you can't get new wire clips). Clean everything up well first and re assemble with some loctite/bearings fit and the wires but straighten the wires a little first so they have a bit of extra spring. I press the bearings in using vice. Sit the wire in the bearing groove and press in until the wire just starts to nip. Then tap the wire down with screwdriver and it will pop into the gear nicely. Easy one you get the knack [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Farm Machinery
Machinery
Krone mower bed problems
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top