Amazone EasyCheck fertilizer calibration mats

marklr90 · Jul 4, 2016

Does anyone know if the Amazone EasyCheck calibration app can be applied and used for other spreaders.

I know it gives calibration settings for Amazone specific spreaders but does anyone know if it can give the raw figures that I could use? Would be much easier and faster than the tray method if possible.

YouTube link:

whindy · Jul 4, 2016

Do most main line makes not have there own apps?

marklr90 · Jul 5, 2016

whindy said:
Do most main line makes not have there own apps?

The EasyCheck calibration map system is an Amazone only developed system, you take a pic of the fert on the mats and gives settings for their spreaders. With regards to other manufacturer apps you're back to the old fashioned tray system, it would be nice if the mats could be used!

peterH · Jul 5, 2016

EasyCheck only applies to Amazone spreaders. The pictures taken of the mats after you have been through with the spreader, gives a reading of how much fertilizer has been collected. These values then get entered into the Amazone control box and it calculates whether a change in blade angle on a ZA-V or drop-point adjustment on a ZA-TS is required.

The EasyCheck system is an evolution of the tray system Amazone use today.

Hope this helps answer your question.

marklr90 · Jul 6, 2016

Thanks "peterH" - if you look at the attached video above, you see the operator gets bar charts on his phone with the quantities above and below desired rates, I was just wondering if them figures could be extracted but most likely not!

Amazone EasyCheck fertilizer calibration mats

marklr90

New Member

whindy

Member

marklr90

New Member

peterH

Member

marklr90

New Member

SFI - What % were you taking out of production?

0 %

Up to 25%

25-50%

50-75%

75-100%

100% I’ve had enough of farming!

May Event: The most profitable farm diversification strategy 2024 - Mobile Data Centres

Share this page