Mouser
Member
- Location
- near Belfast
Oh ok, scrap that idea then.It is not as simple as that all fitting's and valve's need to be rated at 16 bar pressure,if you want to stay on the right side of the HS laws
Oh ok, scrap that idea then.It is not as simple as that all fitting's and valve's need to be rated at 16 bar pressure,if you want to stay on the right side of the HS laws
Compressor will make 16 bar of pressure, I would not want to see someone get hurt but a mz gate valve coming apartIf your only blowing the last few 100m of pipe out the launcher won't have to stand anything like 16bar pressure a hd35 produces that much but as the pipe length increases pressure drops so near the field won't be anything like that, we occasionally just use a T piece with a ordinary tap on it and don't have any trouble
We're not using a mz valve to be fair it's a proper tap as used on a lot of pumps but the best valves we have are ex water main wheel valves they are well able for the pressureCompressor will make 16 bar of pressure, I would not want to see someone get hurt but a mz gate valve coming apart
We're not using a mz valve to be fair it's a proper tap as used on a lot of pumps but the best valves we have are ex water main wheel valves they are well able for the pressure
Somthing like this
Wox one is no good as it is to small & can not be ran on the front of the tractor & from what I have heard it is about the 10K mark
What ?Your chatting sheet
Your chatting sheet
Your 4* hose is killing your flow600m of 5 inche 600 4 inch
Would you care to say why ?rubbish utter rubbish
My opinion is because it's water..Can someone tell me how anyone gets a doda hd35 or a Bauer sx1000 to pump more than 130 cube an hour at 1200m currently 128 cube 9 bar 890 revs with the Bauer in water doda was similar yesterday
We could never get the pressure or volume with dirty water that we could with slurry or dirty water with fiber in on HD35,backing plate tight to impeller as well..My opinion is because it's water..
Is it clean water.dirty water.or dairy washing water???Can someone tell me how anyone gets a doda hd35 or a Bauer sx1000 to pump more than 130 cube an hour at 1200m currently 128 cube 9 bar 890 revs with the Bauer in water doda was similar yesterday
How was the preassure only 9 bar then.surely it would have been far higher if the 4in was the restriction??assuming the preassure guge is on pump.Bigger pipe = higher flow rate