- Location
- Northumberland
Used to do that - still untangling from the PH. It also helps positioning in the muck spreader hire queue.I don't take the net off in the bedder . I just chop it all up .
Used to do that - still untangling from the PH. It also helps positioning in the muck spreader hire queue.I don't take the net off in the bedder . I just chop it all up .
At least. It's not only the even spread, but also the ability to go little and often. When you see how sodden the muck is, it's a wonder the cattle stay clean. My standards for 'for grass again' cattle are lower.A lot . ..I think . I would say we probably use 25/30% less straw ....but its not a scientifically proven fact.
Bulls would soon roll them outMine are 6’2 round….you don’t roll these out
Using spring barley in Mill for cubicles, just flies through very nicely!The worst part is a lot was baled up brittle so if you undo a round bale in the shed it just all falls in a heap and you can't roll it.
Plastic pollutionI don't take the net off in the bedder . I just chop it all up .
into the feed passageBulls would soon roll them out
Unbelievable that you are happy to chuck plastic back on your fieldsI don't take the net off in the bedder . I just chop it all up .
Wouldn't normally but its hopeless trying to get net off .....it always ends up under the bale and the bale falling out all over the place ....its only this yrs straw .Used to do that - still untangling from the PH. It also helps positioning in the muck spreader hire queue.
Didn't have one with the bulls ,just feed binsinto the feed passage
Wouldn't say I was happy about it but the bales are a nightmare . Thankfully only 60 of them and neatly all gone nowUnbelievable that you are happy to chuck plastic back on your fields
I don’t have bulls and they’d just heap it up in the corner….or the water trough…Bulls would soon roll them out
Don’t worry the muck spreader will soon find itI’ve had a lot of silage bales bales wet it can be very difficult to get all the net off them at times
They collapse after a bit of unwinding and even if you work at top speed it’s difficult to get it all at times
Isn't that what contractors are for?Don’t worry the muck spreader will soon find it
I’ve got my own rear discharge so unfortunately it’s me that has to remove any netwrap the beaters find…Isn't that what contractors are for?
Having said that ours couldn't believe after a days spreading there wasn't a single piece of cord and one bit of net wrap on the beaters.
I usually unwind the net like that to make sure I get it all but if the silage is wet I cut the net underneath the bale so none ends up under the silageI’ve had a lot of silage bales bales wet it can be very difficult to get all the net off them at times
They collapse after a bit of unwinding and even if you work at top speed it’s difficult to get it all at times
It’s not that hard to pull net from under straw , just lazy and environmentally a poor thing to do.Stab the bale a few inches from the bottom with the forks and hardly any of the bale will collapse on the net.
But then you wait until they have eaten it in the feed passage or ring feeder, and pull it out !I’m pretty particular about getting all the net off every bale as I don’t want any in my cattle or anywhere else
The fact still remains that with wet silage from time you can end up with the silage on top of some of the net
It happens doesn’t matter who you are
YesBut then you wait until they have eaten it in the feed passage or ring feeder, and pull it out !