Can confirm V12 sims works on 2G , I have the 4 network unsteered sim also, and 3G has now been turned off in my area so it has defaulted back to 2G and works fine.
Looks very similar set up to fendt WAS, as @Wombat says there are 2 types of sensor. One is for auto 4wd and auto diff lock the other does both those things plus a WAS for auto steer.
Thanks @Mr Happy, unfortunately not been able to get a hydraulic schematic diagram as of yet. However local dealer can get the new block off the .2 machines. I have looked through both parts books and all the valves in the block have the same part numbers, Apart from .2 block doesn’t need...
Yes very badly corroded, have just bought the spreader, I knew it was bad before buying but didn’t realise quite how bad it was, and after doing 70 acres today fine it’s now developed a leak.
The valve block controls the disc speed via a couple of PWM valves as far as I’m aware, have found the part number for the 50.2 valve block R 3087516 which looks very similar but will do some more investigation tomorrow to make sure.
Hi would anyone on here know of who makes the hydraulic block for the 50.1 H EMC W fert spreader. Have phones dealers and they say it’s unavailable. Looking for alternatives. The part number is R3087367
I had the same problem a few years back with my 820. It pressurised the fuel tank, and could never got to the bottom of it. Had injectors sent away because of contaminated fuel, and one of the copper washers on the bottom of an injector was slightly damaged. When new injectors had been fitted...
Hi have recently bought a 724 S4 it has a Novotel smart 6 receiver in the roof and the VD03 controller, currently have EGNOS and an option for terrastar L. What other hardware will I need to upgrade it to RTK or is it just an unlock required in the screen?
I have had the same problem as described above so took the AGI -3 apart today, the battery is on the bottom side of the main circuit board, I’m going to order one and see if this resolves the problem hope this picture can point you in the right direction @Hank Hill
Pin 25 on the left hand plug is what I have for remote mapping on my x35 and was the same on the x30 it has 12v supplied to it when mapping, hope this helps 👍🏻
Do you have a picture of the back of the screen? If it is the same as a topcon X30 or X35 I have the external master switch Pinout numbers written down somewhere if that helps.
I have a fendt 820 with the factory fitted auto steer, I when I bought it, it had all the same faults as you have. I replaced the pre control valve under the cab this spring and all works perfectly now.
Hi, I currently have the comfort control unit on the forage waggon and I am just wondering if with the correct wiring harness I can use the ISObus plug and screen in the tractor to save having another screen in the cab.
My 820 did very similar a few years back turned out to be a small hole in the engine oil cooler. Oil was fine on dipstick just a little lower than normal. If I remember correctly I think a new cooler was around £180 and then flushed the cooling system out with a mix of washing powder and water...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.