A lot of useful information there, thanks! The starter p/n is 2873k634 if that means anything?
Unfortunately I really need the machine to be working at 8am on Tuesday so I shall have to fit whatever starter motor I can find locally tomorrow and hope that doesn’t mean I have to do this all again...
Thanks del_boy, mine’s an 08 reg and sounds as though it’s a different set up. My starter is at the back middle, in between the engine and the radiator. Any inspection plate seems to be further than arms length away
I need to replace my starter motor. How on earth do I get at it?
I’m assuming I need to remove the radiator but I’d love someone to tell me there’s an easier way!
The king pin or bearings or something has worn out on the front right of my Manitou MLT731 2008. When I lift the front off the ground the wheel moves quite a lot top to bottom.
Is this a diy repair? Where could I find some instructions? Should I just take it to a specialist?
Any advice...
I used to do the hedges with a compact tractor and a McConnell Swingtrim without too much trouble. Unfortunately I don't have that set up anymore. Remember I'm talking about hedges on a caravan park, not acres and acres of farmland
I'm sure the pump would run it but I'd be going a bit quick to do a tidy job.
I'm now thinking something along the lines of the Kellfri trimmer that was posted earlier as it only requires 15 lpm
There are no markings on it to say that I've found. It's a 2008 MLT731 T if that helps. What markings on the pump or elsewhere should I look for?
Thanks
Thanks for your reply Mr Happy. I'm doing lots of homework and I have no plans to cut up the Farmtrim until I am sure it would work!
I've just started talking to these guys
http://www.slanetrac.co.uk/tractor-front-loader-finger-bar/
But they haven't told be the price yet.
The Kellfri machine...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.