dannewhouse's latest activity

Check the sides of the combine/chassis the cross shaft with the eccentric con rods on pulls the bearing on the u shaping side of the...

I just said, should have had flat plate with bolts for roof and handrail should have been highest point and smooth as possible

Any tips on sheeting the sidewalls, new style clamp, steel uprights with 3high pannels between and a hand rail 3ft above pannel 1ft...

A little bit of noise not much just put it down to spurious brakes, herd worse from others. Ccls

What are the springs made of? Steel or like a bakelite type material?

Just as jerky without using clutch (maybe worse) Same both directions. I'm thinking damper plate or clutch packs never been into clutch...

Is it the same pack for both forwards and reverse? Or would you expect 1 direction to have gone before the other? Any switches, would...

Exactly the same today. My guesses Damper plate? But it's never rattled even then jerky isn't a symptom? Foreward reverse clutch packs??

Half way through bailing yesterday the shuttle has gone really aggressive even if you use the clutch makes no real difference. Any...

It isn't an ideal location but due to milk processing they done want to relocate the whole setup, cubicles are going to be 200m from...

I doubt any signing off, it's not a vertical shaft it's a long tunnel about 7m deep, with plenty of off shoots to each side. Then...

That's a building though, I'm picturing slurry storage being a whole different game. I see no reason why piling in a grid, strip...

any one find a good supplier for the Accumulators?

having the brake accumulator tested, the front axle one is dead, where is best to buy one from, 27mm x 2mm male thread on mine which im...

Has anyone ever done this or know the rules/ regulations wether you can site a cubicle house ideally with a tank underneath over mining...