Recent content by fenrat

Where are you located?

Wanted 3000-5000 wooden Chitting Trays. Price I'm willing to pay will depend on condition. Located as close to Wisbech as possible but I will travel pretty much anywhere is needed. Tia

look great, a lot cheaper than a roller shutter for what youre doing. How much did they cost and where did you get the rollers etc?

Hi there, looking into section control on the Hardi Commander sprayers with the electric nozzle shutoffs. As it is the sprayer has an HC6500 controller with 6 sections. However I think the 6500 can handle up to 13 sections according to a manual I found. Is there a way of using Trimble section...

Just for interest I added these floats to this old converted lorry body this summer pre harvest. Made the trailer 100x better up the road and ruts just dissapeared. Had to move the front axle forward a bit because they're not the same rr as a super single but that actually balanced the drawbar...

The drying floor sections all moved and interlocked

You know I'm all about saving transport costs...... That 45ft artic took some unloading!

I recently did out my bungalow. Solid walls with no damp proof or insulation. I first used damp proof breather membrane for roofes. Then after a 0.5inch air gap there is a wooden stud wall made from 4x2. 75mm of xtratherm foil backed insulation. New wiring then plasterboard and paint. Amazing...

Seen this on Facebook. Not Bailey or Ktwo but still decent build

Is that sitting on the cab roof?

Need the auto section control of the "i" spec really but did spot one on that website also which is a 3200i. Seems a good machine. Shame its in Ireland

Wanted all herbert potato equipment. Any age or condition or location considered.

Wanted a 4000L 24M Trailed Sprayer with auto boom section control either standalone or running off tractor GPS. Will consider bigger/smaller tanks, other makes etc. Intially got a hardi commander 4000i or suchlike in mind

https://www.welduk.com/product/mig-gas-solenoid/ Just check specs against the one on your machine and find something similar. Or ring welding Centre Wisbech and he will sort you out and pop something in the post.

Can you PM me whereabouts you are and how much you would want?