Recent content by Joshherbert

  1. J

    Kuhn vs kverneland four furrow plough

    I’ll take a video when I next use it. Won’t be for a week though.
  2. J

    Kuhn vs kverneland four furrow plough

    Yes turn over is perpendicular. Ploughs running 90 degrees to the ground. I think I’ll test it with the check chains tight so that the plough can’t pull to either side. do you guys run your skimmers in line with the points, or are the set slightly towards to unploughed land? because I’ve also...
  3. J

    Kuhn vs kverneland four furrow plough

    Yea Nah just the one
  4. J

    Kuhn vs kverneland four furrow plough

    Yea it is. Sequencing valve is fine
  5. J

    Kuhn vs kverneland four furrow plough

    Front and rear wheel spacing is even.
  6. J

    Kuhn vs kverneland four furrow plough

    Yea they are the size the manual states. thank you for your help though
  7. J

    Kuhn vs kverneland four furrow plough

    Yea, I do way to many hectares to plough at 14 inches though. It’d take far to long haha
  8. J

    Kuhn vs kverneland four furrow plough

    I’d say it’s tractor at this point
  9. J

    Kuhn vs kverneland four furrow plough

    Nah it should be 40mm for anything below 135cm. The problem would be exaggerated if I wound that cylinder in.
  10. J

    Kuhn vs kverneland four furrow plough

    It’s already at 40mm
  11. J

    Kuhn vs kverneland four furrow plough

    Yea I spend a few hours yesterday widening the front tyre width so it is now exactly as you have just suggested. For the rest of it…… 😂 I do like to think I slightly know what I’m doing haha. I am going to try running the check chains tight rather than free to move however to see if that stops...
  12. J

    Kuhn vs kverneland four furrow plough

    Why Norwood? They’re not a Kuhn dealer? but thanks I’ll give them a call
  13. J

    Kuhn vs kverneland four furrow plough

    This is very much what I’ve been thinking ! The check chains are free to move and you’re correct that the top link isn’t sitting straight behind the tractor, it’s leaning into the ploughed ground. I had assumed it was because of the plough set up. But my thinking has been that perhaps I should...
  14. J

    Kuhn vs kverneland four furrow plough

    Yea they line up
  15. J

    Kuhn vs kverneland four furrow plough

    Yea, I’ve got both of the threads set to the correct length to suit the tractor.
Top