Recent content by yohan115

Ramps are a torture no matter what finish they will be slippy especially in summer I’d recommend the rubber. No way you can work the step?

I have the same age of t7 just run a pipe from green spool at back to power front mower back one into the blue then hit the botton to change joystick to work back spools then you have both functions on the joystick. Simplest way of doing it, sorry didn’t mean to reply to your comment

Do you reckon the brown grass will grow out prior to cutting in 2-3 weeks? If not maybe better cutting at a smaller bulk now and focusing on a good second cut. Hard to know roll the dice and see.

I’d avoid the 7802 tine arms are long and with time shear at the bolt hole which is a poor design IMO, rotors are held on with a circlip which wears and drops drive better makes on the market.

Mchale pickup band

Could you not use concrete pipes ?

I had an issue when the catch/latch was out of adjustment it half sheared the roll pin so looked like it was clipped in but was just catching and no more. Long story short mower parted company with tractor, got away with just bending the pto!

These rotork valves are used in waste water industry should have to torque for you job but will be 3 phase.

Yes knuckle boom pivots in front of window. Good for tight awkward spots but poor lift height. Mono boom more desirable for your work imo !

You could get the local planner man to scarify the entire lane to the same surface say 20-30mm deep surfacing contractor to spray bond coat the lay 40mm of SMA/ asphalt job done drive on it next day. Any tarmac will not sit, will move in hot weather to soft.

Push paddle on forward their is a second click for float.

Mchale have a new heavier duty tine now slightly heavier gauge. I just cut the nuts off old bolts and replace not worth the heartache trying to slacken.

Try a lowloader on air as you could raise the airbags right up and have sprayer tank on demount legs let the air bags down, drive out one less lifting operation. Twist locks also would be a great addition.

Replaced a set of original 650/50 r22.5 with tractor tread 650/45r22.5 much better more clearance. Original tyres kept blocking up stopping the wheel turning.

I have an r-tech cut 50 good for up to 12mm really anything above stick to bottles. Consumables are a rip off postage to Ireland. But other than that been good so far.