Wondered if I could ask for some advice, we are considering investing in activity monitors but ideally don’t want to compromise future integration with a fresh parlour in the near future.
Parlour wise will likely be second hand but with auto iD feed to yield and seg gate. Have been told that...
Afternoon all,
I want to explore the viability of going from bagged sawdust to bulk, Id like to avoid the plastic waste and hopefully see some cost savings.
Has anyone successfully used a silo for sawdust storage? I like the deaf it being sealed and avoiding using up a roofed shed else...
Morning All,
We are looking at putting up a new cubicle building and wanted to know if anyone has had any experience or successes with deep bedding cubicles with milled straw and quite a lot of lime/cubicle sanitiser.
I like the deep bed sand but are planning on putting up a slatted shed so...
Im interested to hear some real life examples of recent parlour installs to include concrete bulk tank etc?
I have heard of attractive parlour prices but by the time they are in and running i should imagine its almost insignificant?
Im interested to hear what you've put in but if we were to...
I know a huge, endless topic and often is discussed on here.
I'm Interested in particular to hear of members who have approached it properly and amicably.
The huge asset value of farms is definitely a huge factor/ hurdle in recent times and wondered what plans people have in place.
If the...
Afternoon all. At home our slurry system involves a channel in the yard, a reception pit, and then the tower. Through the winter we pump into the tower from the reception pit and when spreading we pump again out of the reception cycling into the channel in the yard.
This is done with a Storth...
Evening All, I know this is a rather vague question and have been reading an older thread on here which gives some good ideas of what people are doing and have, but wondered what peoples opinions of best size/value/ output parlour would be?
We are currently milking about 100 through a 7/14...
Evening all,
I have had a few intriguing issues today and was going to ask earlier but now I believe I may have found the issue.
Over the weekend I gave the radiator on our Case MX a good blow out and clean, and it definitely needed it. But the day after the temp gauge seemed to be reading...
Evening all, trying to tidy up the yard and our old bale handler and flat eight are of no use to us anymore. Both are fairly old but should give decent service for lower usage users for a decent time yet.
We are in devon and collection would be best but could probably put the squeezer on a...
Morning all thanks to those who replied to my last topic.
Our case mx has started blowing the linkage fuse quite often and wondered if there was a known area/ wire to look for and repair. Thanks
Evening all, we've recently bought a new f5500 and got a couple of queries ;
1; this may be a tractor issue but maybe you will be able to help, occasionally when I go to lift the door it rises a tiny bit then won't go any further so I have to put it down and up again and it always goes up then...
Morning all, a long shot I know as have been on the lookout for some for ages and they just aren't around if any of you have some or can point me in the right direction I'd be very grateful. Thanks. Liam
Evening all, nice to see this new forum coming along quickly and nicely was sorry to see BFF go.
I just wanted some advice on what oil you use/ recommend for the
Gearbox the manual says sae 90 but I'm struggling to find any! I've got oil I use for the tractor diffs which I think is ep 80/90...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.