If I mark a new AB line after marking the headland boundary I loose the inner boundary line for telling me when to raise or lower the drill. Has anybody got a way around this?
I am having bother getting my head around calibrating my auto pilot
I have roll offset at 0.03 m right of line
I drive one way and I am correct distance from the 2 markers I have set up on a hard surface.
Then I turn around and Tractor is 2 cm to close to the right marker.
I have been...
Is it possible to drive a fendt in TMS and get the engine to automatically rev up to 1000 rpm for pto work such as power harrowing or drilling with a combi drill. I have been trying it and it will only Rev the engine up to reach 700-800 on the pto. I have forward direction and pto switched on in...
I have a new trailed drill that is mounted on the lift arms and it pivots 30 cm behind them. When I am lining up to sow if I am in to narrow the tractor steers out and the drill momentarily steers in which makes the problem worse and the opposite happens when I am out to far. This is leaving me...
When I drive around the field to mark my inner boundary I make my AB line also,but I always find it easier to make a new AB line after the headland tramline as I end up doing to much overlapping when I start to shift the line. My problem is when I make a new AB line I loose my inner boundary. Is...
4m vaddy measuring 3.92 coulter to coulter. What should I have swath width & application width set at. Also is distance B from rear axle to front coulters. Working on RTK.
Finally decided to go down the auto steer route and was wondering is there a need for a 2nd receiver on a trailed 4m vaddy drill. I will be sowing on contract so I need to please customers as much as myself and I also need to sell the system to them so I would rather pay more and be more...
It's a well known fact from reading here that a vaddy drill does not pull straight.What I want to know is which side does it pull to? and would this show up on the screen on any of the popular brands as a miss or an overlap when the coverage is switched on. The drill is a 07 system disc 4 meter...
Thinking of going down the auto steer route.Had a topcon with electric steering wheel for a trial last year working on omnistar HP and G2 signal and I have to say was more than dissapointed with it.The signal was very inconsistent,when it worked,it worked reasonably well and when it lost the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.