Not sure if anyone may have lurking around a manual for a Kuhn GSR25N tedder / rake. Many years since I have used one and seem to remember there are quite a few adjustments on it. Kuhn are not sure if they have a copy so not holding out much hope with them.
The cold start button on our 7810 will not stay pressed in and has to be held in when starting then released when the engine fires. Is this an easy fix?
Does anyone have a loader headstock to suit the old quickie brackets ( I think euro 3 ). I need to make an adaptor plate or change the headstock on a Faucheux loader.
Is anyone aware of an "official" notice that can be printed out to close a footpath across some of our fields. Just thinking that being a bank holiday I may see an increase in walkers so would like to be prepared.
As per the title. Early 7610 permanently in 2wd. Any suggestions where to start checking or anyone know of the common cause? Could really do without spending hours fault finding.
Hi
Our 2wd Ford 4610 (with loader) suffers from total loss of grip in muddy conditions. It is fitted with 16.9R30 rear tyres which are probably approaching 75% worn. Even with a concrete weight on the back it will not go places that our other tractors go easily but they do have narrower tyres...
Has anyone experienced problems with a MF20-8 baler producing different length bales? For some reason they are very dense but also vary widely in length - between 40 and 48 inches. As you can imagine a nightmare to stack!
i am trying to find a transmission mounted hydraulic pump for a Ford 4610 with synchromesh transmission. Preferably a new one but I cannot find a supplier who lists them. Does anyone have any suggestions?
Has anyone had any experience of the repair kits. I am somewhat sceptical of how...
Can anyone tell me where the level plug and filler plug is on the back axle. I know the oil is low as she won’t tips trailer fully but can’t find the filler.
Also does anyone have a manual for this model as I have just bought it and am working things out as I go
I am looking for a set of loader brackets for a Ford 3 cylinder tractor (4610). The loader is a Trima 1430 but I am not sure if all Trima loaders (and Quicke maybe) use the same style brackets. I have a set of 4 cylinder brackets which when I purchased the loader years ago I was told fitted a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.