Search results

I wouldn't buy a 30+ year old loom unless nos. Tried tractor electrics ie but not got back. Looks like i'll have to make my own. Does anyone know of a supplier for the connectors?

What i would give to own a Jensen Intercepter ff! I had a loom made for a car of mine years ago and that was exactly how they made it. I have a second 7810 working atm so could give the shagged loom to someone to copy. I have a 614 and a 275 which were my fathers and use them when we have sunny...

I just have no time to make my own atm. surprised there aren't any aftermarket looms made, i can't be the only one with a 32 year old ford with brittle wiring.

Have tried CNH but no longer available

Hello All, Does anyone know of a company that could make a new wiring loom for the 7810? thanks

How far can the gate pressure be advanced from factory settings as bales were quite loose this year

the lever goes down to 7 on the qaudrant but does not reach full height on the lift arms, no leaks on the lift rams

Have to pull like hell on the lever to lift and the arms do not stay up, is it a complete strip down?

Any being sold in sussex

Has anyone replaced the rear axle seals on a 4600, is there problems to look out for?

they are round lights with 6 leds in them, I will photo them tomorrow and see if in our records the ref no. THe trouble with floodlights is by their very nature it is a harsh light

Yes, basically the same as all the older fords

o every thing as clean as a whistle. That's the problem with these bio-fuels they can create their own garden in the fuel system

We found that led hi-bays every other bay gives perfect lighting and you can get them with a red nightlight. Do not forget that wiring, switch location should conform to agricultural regs, i.e. armoured cable and switches to ip65 and out of the way of cows

so what would the extra cost for safety netting , guard rails and plant

It is a 28 year old machine , 7000 hours and one owner, but we bought it off a dealer. I will let you know how I get on tomorrow.

Yes ,Went over to Germany to see it , but they Could not be bothered to put a bit of diesel in.

I will also check this. Iam usually anal about getting these right but as you have to work around a loader frame as well it could have moved.Shame to have these problems as the tractor is in good condition,not been knocked about and been serviced regulary.

No definitely empty as I put 100 - 120 litres of diesel in tank

The diesel comes up from the tank into the glass bottom water trap into the lift pump then through the filter and onwards to injector pump and injectors. I think in the morning I will connect a 20 litre drum to the inlet of the water bowl and then should be able to bleed through and start the...