Our weather has been a pain for crops this year; growing, harvesting and sowing 🤮. But I was lucky last mon ...an all nighter finished the sowing. Not perfect but the Co will go when a lot of drills were stopped 👍
And still running 👍! I can copy the pages if any use. I have never seen a CO with mechanical drive but often thought it would be fine. I also had trouble last year with intermittent start stop etc as @Two Tone. Horsch tec checked and we replaced the motor module power supply which fixed the...
Thanks...have had shaft out and checked that. Nut was tight, and is now VERY tight!! Hub looked perfect ...still has machining marks on inside...shaft looked perfect on hub seat and cant see any wear. It is not a taper on mine but a parallel fit with keyway (might not be original). Nice push fit...
Fitted and working. €500 (but I didnt push him on time or prob would have been more!) Prop shaft seems to be running smoothly now but still have some vibration...think it is the primary countershaft even though got checked with dial guage in machine shop. Anyway going to use on Spring wheat and...
Ah jeepers that is not good 🤮. Hope evervbody ok. I have a new splined boss made and fitted to my yoke and will be fitting it friday am. All going well Im sorted. Thanks so much for the offer, hopefully you get sorted with machine and harvest.
No Good either (even though casting number same🤷♀️). Has to have spline hole all way through (to enable shaft to be fitted into place) and mine has strap and stud holding caps. Mine looks much heavier I think....thanks anyway- much appreciated
Not the same....much smaller cap size and span😢😢 Diameter of shaft way smaller Id say.
Measurements are correct except for those. I need cap size 41mm (1.61") and s
dist across caps to be 128mm (5.04") approx
Do you have access to the Dana listings?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.