Search results

I have only 2 to do the rest are ok sounds like u had to put a fair bit of work into them

I must do that thanks so much

The wire on the grinder have i to be careful i dont scratch the boards

Does anyone know what is the best way to shine boards of a plough so that the clay doesnt stick , i bought a plough and at the end of every run i scraped the boards but it still sticks

Hi all , i have a battioni 11000 ltr pump that i put new vane in but it is still not performing the way it should , i noticed it is ridged inside and im wondering did anyone ever get a pump honed out and was it sucessful tia

Thanks that is helpful ill try that tomorrow

Def need tippex

Yea i have done them up before mainly seals but imwondering is the bottom oscilating gear worn and letting oil by it same as a hyd motor gets worn

I switched o unit to another tractor and it was doing the exact same thing

Hi im wondering did anyone ever get an orbital unit on a newholland t6 or t7 repaired steering gets v giddy when tractor gets warm

Big turnaround , it seems claas are easier to work on and a lot simpler

Yea I heard the 2cx has a great compressor

It doesn't say on it anywhere ,I'm wondering would a vane pump be down on pressure compared to a scree or piston type

It doesn't say on it anywhere ,I'm wondering would a vane pump be down on pressure compared to a screw or piston type

Hi

What pressure would u need

Hi all,would anyone be able to tell me what kind of air pressure and volume I would need to blow out 1300 MTRS of 4 inch pipes I would say not too thick but as we all know it's generally thick finishing up

But if you have a mig welder it's amazing how you can weld 2 fittings to get you out of bother

Just a couple of things ,you are not on your own a lot of farmers are thinking the same because of the high grant,the costings would not cover a galv tank with auto fill as they would be dearer,but a painted tank with a decent macerator(a must) would be there or there abouts on the cost ,also...