We run our shakerator without the shins on the legs which leaves a much better finish as you don’t get the sideways shatter only the upward lift which then goes back down level. I assume you have a good packer.
I think you are after a finger switch look on Amazon or eBay
Attach to tractor and when top link raises switches off and on when lowered
We clamp ours to the pickup hitch lift rod with a g clamp
We had this problem recently in exactly the same conditions and found that two of the arms carrying the disc’s had got slightly bent presumably running over a rock or concrete however replaced arms and no more problems also make sure that you have angled the drill back another turn for wetter...
If I remember correctly the points are reversible and it was possible to weld new tips on so a piece of hard flat bar could solve your problem just remember to cut the old tip off in the same place on each point
Very interesting comments, I think it's all about the rapport you have with the manager. Have been with Natwest for some time just got a new manager and not a patch on the last one. Time for a change I think - not very difficult these days! Will be interviewing in the next couple of weeks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.