seriddick
Member
- Location
- south west scotland
Dose anyone know what machine setting you need soyl opti at to pair up with cci isobus on a Kuhn h emc ?
soyl opti paring
- Thread starter seriddick
- Start date
seriddick
Member
- Location
- south west scotland
Called a few times today no answer was not sure if any of then were on here
- Location
- All over the place
Yes you can:
Required is KUHN Part no 1288033, which is the same RS232 cable set used for a GPS receiver for auto shut off etc - & that connects to port ‘RS232- i’ (HW1) or‘D1’(HW2) on the CCi box. Connect to ‘RS232- ii’ (HW1) or‘D2’(HW2) for Variable Rate. All KUHN CCi Boxes should have CCI CONTROL & CCI CONVERT
Apps unlocked – however they might need activating by a KUHN dealer before they can be used. The icons will then show up on the setup menu – press ‘house’
button on CCi Front panel (below screen) if you PM me your email I will send you the pdf instructions we have for this.
Required is KUHN Part no 1288033, which is the same RS232 cable set used for a GPS receiver for auto shut off etc - & that connects to port ‘RS232- i’ (HW1) or‘D1’(HW2) on the CCi box. Connect to ‘RS232- ii’ (HW1) or‘D2’(HW2) for Variable Rate. All KUHN CCi Boxes should have CCI CONTROL & CCI CONVERT
Apps unlocked – however they might need activating by a KUHN dealer before they can be used. The icons will then show up on the setup menu – press ‘house’
button on CCi Front panel (below screen) if you PM me your email I will send you the pdf instructions we have for this.
- Location
- All over the place
